51 Gallon Aluminum Rectangle DOT Powder Coated Transfer Tank w/ GPI HP100 Pump

Description

51 Gallon Aluminum Rectangle DOT Powder Coated Transfer Tank w/ GPI HP100 Pump Transfer Tank Package includes a 51 gallon powder coated aluminum refueling transfer tank designed for diesel or gasoline. The package also comes with a GPI HP100 lever actuated hand pump.*DOT Certified Transfer TankPlease Note: Additional freight charges will be included on all tanks going to Alaska, Hawaii, and Puerto Rico.Attention: Adhere to these guidelines before installation. Failure to follow these guidelines will result in voiding your warranty.The fill cap location and pump location cannot be swapped.Do not install risers between the fuel tank fitting and the pump.Do not use extension pipes to raise the height of the transfer pump.Do not install a pump over 30 lbs. to a standard duty tank. For pumps over 30 lbs., a Severe Series tank must be used. The 30 lb. limit includes pump and any other accessories such as filter kit, meters, etc.FeaturesAll Aluminum ConstructionBlack Powder Coated FinishTwo 2 in. Female NPT BungsFully Baffled to Reduce Fluid MovementLockable Vent/Fill CapDOT Approved for Gas and DieselPressure and Leak TestedSpecificationsTank SpecificationsImportant Notes:Mounting tabs extend out 1 1/2 in.Add 2 1/2 in. for fill cap heightA: 24 in.B: 60 in.*C: 9 in.*Note: 55 in. across the bottom; sides of tank taper in at bottomPump SpecificationsMaterial:Lightweight, die-cast aluminum housing.Stainless steel piston shaft and liner.Buna-N seals.Built-in air valve to prevent leakage at the nozzle.Non-UL Model:3/4 in. 8 ft. Buna-N hose. Thermoplastic unleaded nozzle.Built-in nozzle holder.UL Model:UL Model:3/4 in. 8 ft. Electrically Conductive hose (UL Listed) with metal nozzle.Suction Pipe: Plastic, adjustable 22 to 40 in.Pumping Capacity: 1/2 gallon (1.9 litres) per stroke cycle.Inlet: 1 in. NPTOutlet: 3/4 in. NPTShipping Weight: 14 lbs.Hose and Nozzle:Pumping Settings: 1/2 gallon setting for high volume, high resistance. 1/4 gallon setting for low volume, low resistance.Pumping Settings: 1/2 gallon setting for high volume, high resistance.1/4 gallon setting for low volume, low resistance. Notes:Mounting tabs extend out 1-1/2 in.Add 2-1/2 in. for cap heightPumps with aluminum threads must be coated with Anti-Seize prior to installation. Do not dry fit. Do not use teflon tape or pipe dope.Do not install a pump over 30 lbs. to a standard duty tank. For pumps over 30 lbs., a Severe Series tank must be used.This tank must be grounded to your vehicle. Metal to metal contact between mounting hardware and truck bed or running a ground wire to one of the mounting bolts.* The 30 lb. limit includes pump and any other accessories such as filter kit, meters, etc. Failure to follow these guidelines will result in voiding your warranty. Do not install riser between the fuel tank fitting and the pump.DownloadsInstallation Instructions (PDF Download)